|
| class | ns3::AdhocAlohaNoackIdealPhyHelper |
| | create the AlohaNoackNetDevice More...
|
| |
| class | ns3::AlohaNoackMacHeader |
| | Header for the AlohaNoack NetDevice. More...
|
| |
| class | ns3::AlohaNoackNetDevice |
| | This devices implements the following features: More...
|
| |
| struct | ns3::BandInfo |
| | The building block of a SpectrumModel. More...
|
| |
| class | ns3::ConstantSpectrumPropagationLossModel |
| | A Constant (fixed) propagation loss. More...
|
| |
| class | ns3::FriisSpectrumPropagationLossModel |
| | Friis spectrum propagation loss model. More...
|
| |
| class | GlobalPathlossDatabase |
| | Store the last pathloss value for each TX-RX pair. More...
|
| |
| class | ns3::HalfDuplexIdealPhy |
| | This PHY layer implementation realizes an ideal OFDM PHY which transmits half-duplex (i.e., it can either receive or transmit at a given time). More...
|
| |
| struct | ns3::HalfDuplexIdealPhySignalParameters |
| | Signal parameters for HalfDuplexIdealPhy. More...
|
| |
| class | ns3::MatrixBasedChannelModel |
| | This is an interface for a channel model that can be described by a channel matrix, e.g., the 3GPP Spatial Channel Models, which is generally used in combination with antenna arrays. More...
|
| |
| class | ns3::MicrowaveOvenSpectrumModel5MhzInitializer |
| | Init a static class containing the MWO #2 model (5Mhz) More...
|
| |
| class | ns3::MicrowaveOvenSpectrumModel6MhzInitializer |
| | Init a static class containing the MWO #1 model (6Mhz) More...
|
| |
| class | ns3::MicrowaveOvenSpectrumValueHelper |
| | This class provides methods for the creation of SpectrumValue instances that mimic the Power Spectral Density of commercial microwave ovens based on the measurements reported in the following paper: Tanim M. More...
|
| |
| class | ns3::MultiModelSpectrumChannel |
| | This SpectrumChannel implementation can handle the presence of SpectrumPhy instances which can use different spectrum models, i.e., different SpectrumModel. More...
|
| |
| class | ns3::NonCommunicatingNetDevice |
| | This class implements a device which does not communicate, in the sense that it does not interact with the above protocol stack. More...
|
| |
| class | ns3::RxSpectrumModelInfo |
| | The Rx spectrum model information. More...
|
| |
| class | ns3::ShannonSpectrumErrorModel |
| | This class implements the error model described in this paper: N. More...
|
| |
| class | ns3::SingleModelSpectrumChannel |
| | SpectrumChannel implementation which handles a single spectrum model. More...
|
| |
| class | ns3::SpectrumAnalyzer |
| | Simple SpectrumPhy implementation that averages the spectrum power density of incoming transmissions to produce a spectrogram. More...
|
| |
| class | ns3::SpectrumAnalyzerHelper |
| | Class to allow the Spectrum Analysis. More...
|
| |
| class | ns3::SpectrumChannel |
| | Defines the interface for spectrum-aware channel implementations. More...
|
| |
| class | ns3::SpectrumChannelHelper |
| | Setup a SpectrumChannel. More...
|
| |
| class | ns3::SpectrumConverter |
| | Class which implements a converter between SpectrumValue which are defined over different SpectrumModel. More...
|
| |
| class | ns3::SpectrumErrorModel |
| | Introspection did not find any typical Config paths. More...
|
| |
| class | ns3::SpectrumInterference |
| | This class implements a gaussian interference model, i.e., all incoming signals are added to the total interference. More...
|
| |
| class | ns3::SpectrumPhy |
| | Abstract base class for Spectrum-aware PHY layers. More...
|
| |
| class | ns3::SpectrumPhyHelper |
| | Create and configure several SpectrumPhy instances and connect them to a channel. More...
|
| |
| class | ns3::SpectrumPropagationLossModel |
| | spectrum-aware propagation loss model More...
|
| |
| struct | ns3::SpectrumSignalParameters |
| | This struct provides the generic signal representation to be used by all wireless technologies. More...
|
| |
| class | ns3::SpectrumValue |
| | Set of values corresponding to a given SpectrumModel. More...
|
| |
| class | ns3::ThreeGppChannelModel |
| | Channel Matrix Generation following 3GPP TR 38.901. More...
|
| |
| class | ThreeGppChannelTestSuite |
| | Test suite for the ThreeGppChannelModel class. More...
|
| |
| class | ns3::ThreeGppSpectrumPropagationLossModel |
| | 3GPP Spectrum Propagation Loss Model More...
|
| |
| class | ns3::TraceFadingLossModel |
| | fading loss model based on precalculated fading traces More...
|
| |
| class | ns3::TvSpectrumTransmitter |
| | SpectrumPhy implementation that creates a customizable TV transmitter which transmits a PSD spectrum specified by user-set attributes. More...
|
| |
| class | ns3::TvSpectrumTransmitterHelper |
| | Helper class which uses TvSpectrumTransmitter class to create customizable TV transmitter(s) that transmit PSD spectrum specified by user-set attributes. More...
|
| |
| class | ns3::TxSpectrumModelInfo |
| | The Tx spectrum model information. More...
|
| |
| class | ns3::WaveformGenerator |
| | Simple SpectrumPhy implementation that sends customizable waveform. More...
|
| |
| class | ns3::WaveformGeneratorHelper |
| | Create a Waveform generator, which can be used to inject specific noise in the channel. More...
|
| |
| class | ns3::WifiSpectrumValue5MhzFactory |
| | Implements Wifi SpectrumValue for the 2.4 GHz ISM band only, with a 5 MHz spectrum resolution. More...
|
| |
| class | ns3::WifiSpectrumValueHelper |
| | This class defines all functions to create a spectrum model for Wi-Fi based on a a spectral model aligned with an OFDM subcarrier spacing of 312.5 KHz (model also reused for DSSS modulations) More...
|
| |
Here is the call graph for this function:
1.9.1 
